ass日本风韵熟妇pics男人扒开女人屁屁桶到爽|扒开胸露出奶头亲吻视频|邻居少妇的诱惑|人人妻在线播放|日日摸夜夜摸狠狠摸婷婷|制服 丝袜 人妻|激情熟妇中文字幕|看黄色欧美特一级|日本av人妻系列|高潮对白av,丰满岳妇乱熟妇之荡,日本丰满熟妇乱又伦,日韩欧美一区二区三区在线

噴霧降溫風機風筒優化設計與試驗
CSTR:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

鎮江市科技項目(NY2018007),、江蘇省六大人才高峰項目(2015-ZBZZ-021)和江蘇高校優勢學科建設工程項目(PAPD-2018-87)


Optimization Design and Experiment of Air Duct on Spray Cooling Fan
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    為緩解高溫?zé)岷?duì)茶果樹的影響,,基于圓弧板型葉片模型設計了一種噴霧降溫風機,,并對風筒結構進行建模和動力學仿真,。以出風口直徑、進風段長度和出風段長度為試驗因素,,以風機出口總壓和風速為試驗指標,,采用DesignExpert 8.0.6軟件優化風筒結構參數。優化結果表明,,各因素對出口總壓和風速的影響由大到小依次為出風口直徑,、出風段長度、進風段長度。最優參數組合為出風口直徑1070mm,、進風段長度350mm和出風段長度270mm,。選取WJ-7010、WJ-8010型噴嘴,,利用優化后的風筒結構進行了風速試驗和噴霧降溫性能試驗,。風速試〖JP2〗驗表明,當風筒出風口直徑和總長度分別為1070,、840mm時,,出風口風量為701.30m3/min,最大風速為16.00m/s,,〖JP〗有效送風距離約為55.00m,。噴霧降溫性能試驗結果表明,當使用WJ-8010型噴嘴時,,與對照組相比,,平均溫度降低0.68~11.11℃,最大溫差范圍為1.80~13.90℃,。在38℃高溫環境下,,噴霧降溫風機在20m范圍內的降溫幅度接近5℃,降溫效果良好,。

    Abstract:

    In order to remit the effect of high temperature damage on tea and fruit trees, a spray cooling fan with lowpower consumption was designed. According to the structure size of arc plate fan blade, the structure of air duct on the spray cooling fan was modeled by Pro/E software. And the dynamic simulation was applied with Fluent software. The diameter of air outlet, length of air inlet and length of air outlet were selected as experimental factors. The total outlet pressure and wind speed were taken as indicators, which were obtained by dynamic simulation. DesignExpert 8.0.6 software was used to optimize the structure of air duct. Then, two types of nozzles with WJ-7010 and WJ-8010 were determined with flow test. With two nozzles, the optimized air duct was carried out to conduct wind speed test and spray cooling performance test. The optimized results showed that the order of significance was outlet diameter, outlet length and inlet length. The optimized combination was outlet diameter of 1070mm, inlet length of 350mm and outlet length of 270mm. Combined with the length of fan section of 220mm, total length of the duct was 840mm. Based on the outlet diameter of 1070mm and total length of 840mm, the outlet air volume, maximum wind speed and effective air supply distance were 701.30m3/min, 16.00m/s and 55m, respectively. The cooling performance test result showed that the average temperature was decreased by 0.68~11.11℃ and the maximum temperature difference range was 1.80~13.90℃ when WJ-8010 nozzle was used. At a high temperature of 38℃, the cooling range of spray cooling fan within a range of 0~20m was close to 5℃. This machine could relieve the high temperature stress problem of tea and fruit trees.

    參考文獻
    相似文獻
    引證文獻
引用本文

杜哲,胡永光,仇樹成,陳永鑫.噴霧降溫風機風筒優化設計與試驗[J].農業機械學報,2020,51(8):118-125,151. DU Zhe, HU Yongguang, QIU Shucheng, CHEN Yongxin. Optimization Design and Experiment of Air Duct on Spray Cooling Fan[J]. Transactions of the Chinese Society for Agricultural Machinery,2020,51(8):118-125,151.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2019-11-07
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期: 2020-08-10
  • 出版日期: 2020-08-10
文章二維碼