ass日本风韵熟妇pics男人扒开女人屁屁桶到爽|扒开胸露出奶头亲吻视频|邻居少妇的诱惑|人人妻在线播放|日日摸夜夜摸狠狠摸婷婷|制服 丝袜 人妻|激情熟妇中文字幕|看黄色欧美特一级|日本av人妻系列|高潮对白av,丰满岳妇乱熟妇之荡,日本丰满熟妇乱又伦,日韩欧美一区二区三区在线

基于CFD的泵裝置性能預測方法比較
CSTR:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

“十一五”國家科技支撐計劃資助項目(2006BAB04A03)和國家自然科學基金資助項目(60974099)


Comparison on Performance Prediction Methodologies of Low-head Pump Systems Based on CFD
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    以某混流泵裝置為例,采用CFD技術分別進行包括進出水流道和水泵在內的水泵裝置全流道數值模擬的性能預測和由不帶泵進出水流道數值模擬得到的流道效率與泵效率乘積的泵裝置性能預測,,并與模型裝置試驗結果進行比較,。結果表明,,根據水泵裝置全流道數值模擬方法進行的裝置性能與模型試驗結果誤差較??;以流道效率與泵效率乘積的方法預測裝置效率的誤差較大,,僅在最優工況點附近與模型試驗泵裝置效率近似相等,,引起較大誤差的主要原因是基本理論存在不合理性。因此,,建議以進水流道,、出水流道和水泵作為整體進行內流數值模擬和裝置性能預測,,并在考慮泵對流道影響的情況下進行流道的水力設計優化,。

    Abstract:

    A mixed-flow pumping system was selected as the study case based on CFD technologies. Two difference methodologies of flow field analysis and performance prediction were conducted. One method was that the system efficiency was the production of pump efficiency with passage efficiency obtained by separate numerical simulation of suction box and discharge passage without pump. The other one was based on the simulation of whole pumping system including the suction box, discharge passage and pump. The predicted results from the two different methodologies were compared with model system test results, which showed that the predicted errors were different. The error of pumping system efficiency was smaller when the numerical simulation of whole pumping system was adopted, while the error was much greater when the system efficiency was predicted by the production of passage efficiency with pump efficiency, approximately equal only near the best efficiency point. The larger errors in predicting pumping system efficiency for the first method were mainly caused by unreasonable theoretic foundation. Therefore, it is suggested that the suction box, discharge passage and pump should be taken as a whole in numerical simulation and performance prediction and the effect of pump should be considered in the optimal hydraulic design of suction box and discharge passage. 

    參考文獻
    相似文獻
    引證文獻
引用本文

張仁田,岳修斌,朱紅耕,姚林碧.基于CFD的泵裝置性能預測方法比較[J].農業機械學報,2011,42(3):85-90. Zhang Rentian, Yue Xiubin,Zhu Honggeng, Yao Linbi. Comparison on Performance Prediction Methodologies of Low-head Pump Systems Based on CFD[J]. Transactions of the Chinese Society for Agricultural Machinery,2011,42(3):85-90.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期:
文章二維碼