A new kind of measurement method for ball nut was put forward, which was based on computer vision to measure shape and position errors of ball nut. Firstly, digital image of ball nut was collected by DH-HV3000FC device, and was input into computer by IEEE1394 digital card. Secondly, original gray level image with noise was changed into edge information with single-pixel width after it had been processed by pre-processing, image segmentation and thinning, etc. Thirdly, roundness, cylindricity, ball-way circular runout, concentricity of ball-way axis to the outside cylindrical axis of the ball nut were calculated and measured by compiled program. The value measured was respectively f1=8.34μm,f2=11.94μm,,f3=1.76μm,,f4=8.87μm. The value measured met the shape and position tolerance requirement of the ball nut. Lastly, the reason of error was analyzed. Theoretical analysis and experimental results showed that this method is feasible and correct.
參考文獻
相似文獻
引證文獻
引用本文
賀秋偉,王龍山,劉慶民,李國發.基于計算機視覺的滾珠螺母形位誤差檢測[J].農業機械學報,2007,38(8):159-163.[J]. Transactions of the Chinese Society for Agricultural Machinery,2007,38(8):159-163.